Home | Privacy Policy | Contact Us | Return Policy

Products Page

SUNUS, LEVELUK R, K8, Leveluk DXII, Leveluk JRII, Leveluk SD501, SD501 Platinum, SUPER501, Leveluk SD501U.
 

Water Filtration Products

Kangen Water Research
 Alkaline Health Books
 Kangen Water Videos

Compatible Kangen Water Replacement Filters
HIGH Performance Filter
 HIGH Performance HGN
PREMIUM Performance Filter
PREMIUM Performance HGN
ULTRA Performance Filter
ULTRA Performance HGN
UltraPremium Kangen Filter 
UltraPremium Kangen HGN Filter

Reusable Cleaning Cartridge

One Time Use HGN Cleaning Cart.
 One Time Use Cleaning Cart.
REUSABLE Cleaning Cartridge
REUSABLE Cleaning HGN Cartridge Crystaline Cleaning Granules

Pre-filters & Housings

Faucet
Diverters & Hoses
 

Shower Filters
Rainshower Shower Filter
Crystal Quest Shower Filter

Bath & Pool Filtration

Crystal Bath Ball Filter and Replacement Pouch

Whole House Filters

Singflo Water Pump

Testing Kits & Meters

Alkaline Water Test Kit
 WaterSafe Test Kit
Fluoride/Chlorine Test Kit pHydrion pH Test Paper

Health Books


Reverse Aging
Alkalize or Die

Powerful Magnets


Hard Water Magnetizer

watersafe® Water Test     
For city or municipal source water

Watersafe® Lead Test Kit Instructions

The Watersafe® Lead Test can detect dissolved lead at levels below the EPA Action level of 15 parts per billion (ppb). Folks this is one test you should have.  In the US about 1,000,000 children under the age of six have a blood lead level exceeding the level of concern. Just take 10 minutes to protect your family from the damaging effects of lead.

Lead Test Instructions

1. Open Lead packet and take out all contents. The packet contains a test vial, a dropper pipette, two Watersafe® Test Strips, and a desiccant (to be discarded).

2. Using dropper, place exactly TWO dropper-fuls of water sample into test vial. To pick up the sample, tightly squeeze the bulb at the end of the dropper and place the open end into the water sample. Release the bulb to pick up the sample, then squeeze again to expel the sample into the vial.

3. Swirl vial gently for several seconds. Place on a flat surface.

4. Place both test strips into the test vial, with arrows pointing DOWN.

5. Wait 10 minutes. Do not disturb strips or vial during this time. Blue lines will appear on the strips.

6. Take the strips out of the vial and lay them on a flat surface with the arrows pointing to the LEFT. 

Interpreting The Results

Negative: The LEFT line (next to number 1) is darker than the RIGHT line (next to number 2)


If you only see the LEFT line (next to number 1), the test is negative)

Positive: The RIGHT line (next to number 2) is darker than the LEFT line (next to number 1), or lines are equally dark (Both LEFT and RIGHT lines are equally dark)

7. Note: If no lines appear, or both lines are very light, the test did not run properly and the result is not valid. If a test strip shows a positive result, your water sample may contain lead or pesticides at a toxic level.

[Watersafe City Water Test Kit Page] [Watersafe Well Water Test Kit Page]

[Water Test Kit Page]